| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY
15. Transfer
a. Install ball bearing
Gear Housing
(14) on the power
driven shaft (3)
as follows:
1.
Lubricate the
inside diameter of
bearing race with
engine oil. Then,
place the bearing
over forward end of
driven shaft and
start it straight
on the bearing
surface of the
shaft.
2.
Place two split
plates on two steel
supports on the
bed of a hydraulic
press with the
recess in the
plates facing
down.
3.
Lower the forward
end of the shaft
with bearing
straight down
through the split
plates. Rest the
inner race of the
bearing with the
upper end of the
shaft under the
ram of the press.
6-808
|
||
|
||
