| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
3.
Place a drive gear bearing
with the number on race of
bearing facing up and,
start it straight on hub
of drive gear.
4.
Place a 3 inch ID steel
sleeve approximately 8 inch
long over end of drive shaft
and rest on inner race of
bearing.
5.
Place a steel plate on top
of steel sleeve and under
ram of press, bring ram of
press down on plate and
press the bearing straight
down against shoulder on
hub of drive gear.
6.
Reverse the position of
the drive gear on bed of
press, and install the
second ball bearing on
opposite end of drive gear
hub in the same manner as
described above.
7.
Remove spare drive shaft.
p. Install the power drive gear
assembly in the transfer gear
housing as follows:
1.
Lubricate the rear drive
gear bearing (the bearing
on the long protruding end
of the gear hub) with
engine oil.
6-817
|
||
|
||
