Custom Search
TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
o. Thread a piston remover Use tool J4746
into each of two tapped (T-head bolt).
holes in the forward face
of the reverse clutch
piston (12).
p. Place a 2 inch X 4 inch X 2
foot length of wood block
over the edge of the
reverse gear housing and
beneath the cross bar of
each remover tool. Push
down evenly on the end of
the two wood blocks, and
break the oil seal (vacuum
lock) in back of the
piston, thus freeing the
piston (12) in the housing.


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business