| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSPECTION (Cont)
20. Drive Shaft
Inspect for corrosion or
Lubricate the
Pilot Bearing
pitting.
bearing with
(52)
light engine
oil; then, while
holding the
bearing inner
race from
turning, revolve
the outer race
slowly by hand
to check for
rough spots in
the bearing.
Rough spots in
the bearing is
sufficient cause
for rejection.
21. Planetary
Inspect for a maximum backlash
Replace assembly
Gear
of .015 inch between any two
if backlash is
Assembly
gears within assembly.
excessive.
(7)
REPAIR
22. Flywheel
Ring Gear
(2)
NOTE
Observe whether the ring gear teeth are chamfered. The replacement gear must be installed so
that the chamfer on the teeth faces the same direction with relationship to the flywheel as on the
gear that is to be removed.
6-867
|
||
|
||
