| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REPAIR (Cont)
NOTE
Heat indicating "crayons", which are placed on the ring gear and melt at a pre-determined
temperature, may be obtained from most tool vendors. Use of one of these "crayons" will insure
against overheating the gear.
e. Use a pair of tongs to place
the gear on the flywheel with
the chamfer, if any facing
the same direction as on the
gear just removed.
f. Tap the gear into place
against the shoulder on the
flywheel. If the gear cannot
be tapped into place readily,
remove it and apply additional
heat, heeding the above
caution about overheating.
REASSEMBLY
23. Flywheel
a. Install oil passage plugs
1. If removed.
and Forward
(63).
Clutch
2. Plugs should
be flush or
slightly
below the
outer surface
of the
flywheel.
b. Support the flywheel (1) on
wood blocks with the forward
(ring gear) side up.
c. Install the pilot bearing
Use a pair of
oil seal retaining ring
small-nose
(54) in the ring groove in
pliers.
the flywheel (1).
6-869
|
||
|
||
