| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
o. Carefully slide the feeler
gage around between the
outer seal ring (36) and the
gear housing (19) and check
for any bind on the feeler
gage. Then, check the
clearance between the inner
seal ring (34) and the gear
housing. If a bind occurs,
the lip of the seal ring may
have turned up or the piston
may not be centrally located.
p. If the lip of either of the
seal rings has turned up,
remove the piston (12) and
install a new seal ring.
Recheck the clearance.
q. If the piston (12) is not
centered, tap the face of
the piston (opposite the
bind) lightly with a plastic
hammer. If the bind still
exists, remove the piston
and turn 120or 240
,
reinstall the piston (12)
and again check the clearance.
r. Place the reverse ring
gear (9) on the work bench,
with the forward face of the
ring gear down.
s. Place the reverse clutch
plate (10) on top of the
reverse ring gear (9).
t. Install the retaining ring
(33) in the groove in the
top inner diameter of the
ring gear (9).
6-893
|
||
|
||
