| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
ad. Tighten the clamps and
draw the drive plate
(11) straight into the
gear housing until
the retaining ring
groove in the housing
is exposed.
ae. If the three dowel pins
(32) extend above the
face of the drive plate
(11) push or tap the
pins down flush with
the face of the drive
plate.
af. Starting at the lower
edge of the gear
housing (19), feed
the retaining ring (13)
in the groove in the
gear housing. Then,
remove clamps, board
and blocks.
NOTE
The ends of the retaining ring, when installed in the gear housing, must always be directly above
the oil drain hole in the gear housing.
ag. Install a retaining
ring retaining spring
pin (30) in each of the
three holes in the
forward face of the
drive plate (11).
Then, tap the spring
pins in the drive
plate to within 1/16
inch of the outer
surface of the retaining
ring with a punch and
hammer.
6-899
|
||
|
||
