| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-41. POWER TAKE OFF COUPLING AND VIBRATION DAMPER (Continued).
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
1.
Power
a. Remove power take-off.
Refer to
Take-Off
Coupling
NOTE
For removal of the clutch drive adapter (1) only from the coupling assembly proceed.
b. Remove the six bolts (2) and
lockwashers (3) securing the
drive adapter (1) to the
flange of the coupling
(4). Then, remove the drive
adapter from the flange of
the coupling.
NOTE
For removal of the coupling assembly, accessory pulley, clutch driving ring and
clutch drive adaptor as an assembly from the crankshaft perform the following
steps c through g.
c. Use slide hammer J5901-1 and
clutch pilot bearing remover
adaptor J5901-2 to remove the
pilot bearing (5). If a
pilot bearing retainer (6) is
used with the pilot bearing,
use slide hammer J5901-1 and
adapter J6758 to remove the
pilot bearing retainer (6).
d. Remove the coupling to crank-
shaft bolt (7) and special
washer (8) securing the
clutch drive coupling and
flange assembly (4) to the
engine crankshaft. Remove
the special washer from the
bolt, then reinstall the bolt
approximately half way in the
crankshaft.
6-920
|
||
|
||
