| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-41. POWER TAKE OFF COUPLING AND VIBRATION DAMPER (Continued).
LOCATION/ITEM
ACTION
REMARKS
CLEANING
2.
Power Take-Off
Coupling and
Vibration Damper
WARNING
Dry cleaning solvent, P-D-680, used to clean parts, is potentially dangerous to personnel and
property. Avoid r epeated or prolonged skin contact. Do not use near open flame or excessive
heat. Flash point of solvent is 100138 (3859 ).
-
F
-
C
Wear protective eye goggles when using compressed air.
CAUTION
Do not allow the rubber bonded vibration dampers and coupling and flange
assembly to remain in the dry cleaning solution or the rubber may be loosened.
They should be cleaned in dry cleaning solution and dried with compressed air
immediately after being cleaned.
Wash all parts with dry cleaning
solution P-D-680. Then dry with
compressed air.
INSPECTION
3.
Power
a. Examine the clutch pilot ball
Take-Off
bearing (5) for corrosion or
pitting. Lubricate the bearing
with light engine oil. Then
while holding the bearing inner
race from turning, revolve the
outer race slowly by hand. Any
rough spot in the bearing is
cause for rejection.
6-930
|
||
|
||
