Tweet |
Custom Search
|
|
|
||
TM 55-1905-222-14
2.4.2 LCM-8 Operation. Both propulsion engines are used during normal operation. After the engine warm-up and
verification that all systems are operating normally, perform the following procedure:
a.
RELEASE AND Cast off the mooring lines between LCM-8 and the dock. Stow mooring lines.
b.
Shift the propulsion controls (1) from NEUTRAL position into FWD or REV gear position which is identified by
a detent feel at approximately 30 degrees from the vertical.
c.
Proceed with caution using the steering wheel and the propulsion controls to maneuver the LCM-8 away from
the dock.
CAUTION
Do not shift the propulsion controls from AHEAD mode to the ASTERN mode or rice
versa through the NEUTRAL position at engine speeds over 800 RPM. Shifting
gear mode through NEUTRAL at high engine speeds will strain the marine
transmission, cause excessive friction in the clutch mechanism, and produce a
damaging shock load on the propulsion machinery. Reduce engine speed to IDLE
(550 rpm) before shifting from one gear mode to another.
Change 6 2-44
|
||