| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
Section I. LUBRICATION INSTRUCTIONS
3-1 GENERAL LUBRICATION INSTRUCTIONS.
This section contains general lubrication instructions that are not covered in the lubrication orders Refer to
LO 55-1905-222-12 and LO 5-2815-231-12 for detailed lubrication information applicable to the LCM-8. The
LCM-8 crew should be familiar with and adhere to the following lubrication instructions:
a.
Keep all lubricant containers closed and stored in a clean, dry place. Allow no dust, dirt, or other
foreign material to mix with the lubricants.
b
Keep all lubrication equipment, such as grease gun, clean and ready for use.
c
Wipe all lubrication points free of dirt and old grease before lubricating equipment. Clean all lubrication
points after lubricating equipment to prevent accumulation of Foreign matter.
d.
Lubricate equipment periodically as shown on lubrication orders.
Section II. TROUBLESHOOTING PROCEDURES
3-2 TROUBLESHOOTING PROCEDURES.
This paragraph provides information useful in diagnosing and correcting unsatisfactory operation or failure of
LCM-8 systems and equipment. Troubleshooting procedures in this manual are limited to the basic craft.
Refer to TM 5-2815-231-14 for engine and transmission troubleshooting procedures. Before using the
troubleshooting procedures, ensure that all applicable operating procedures have been performed.
NOTE
The table lists the common malfunctions which you may find
during operation or maintenance of the equipment. You
should perform tests/inspections and corrective actions in the
order listed.
This manual cannot list all malfunctions that may occur, nor
all tests or inspections and corrective actions.
If a
malfunction is not listed or is not corrected by the listed
corrective actions, notify your supervisor.
3-2
|
||
|
||
