ADJUST CLUTCH LINKAGE (Continued) - TM-55-1905-222-140223

Custom Search

ADJUST CLUTCH LINKAGE

TM-55-1905-222-14 Landing Craft Mechanized (LCM-8) (ROHR and Gunderson Models) (1905-01-284-2647 AND 1905-01-284-2648) Manual

ADJUST CLUTCH LINKAGE (Continued)

TM 55-1905-222-14

4-24

ADJUST CLUTCH LINKAGE (Continued).

Check the clutch control valve lever (4) for slight end play in both "gear engage" positions

If no play is felt, loosen locknut (5) and adjust rod end (6) for NEUTRAL position Then re-tighten

CAUTION

It is important that the clutch control valve lever is not trying to push

or pull beyond a solid stop.

Damage to the control system (and

possible failure of the control system) can result if the clutch control

valve lever is trying to exert too much pressure against any solid

stops.

Cycle propulsion control lever to check for

full 60 travel of the propulsion control

lever,

and 3 inches travel of the clutch

control valve lever (4).

Double-check adjustments by pulling out pin (7)

and cycling the clutch control valve lever (4)

using knobs (8) on transmission control unit.

4-48