Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

Custom Search

INTERMEDIATE DIRECT SUPPORT MAINTENANCE-cont.

TM-55-1905-222-14 Landing Craft Mechanized (LCM-8) (ROHR and Gunderson Models) (1905-01-284-2647 AND 1905-01-284-2648) Manual

Troubleshooting

TM 55-1905-222-14

Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT

(TMDE); AND SUPPORT EQUIPMENT.

5-1

COMMON TOOLS AND EQUIPMENT.

For authorized common

tools and equipment,

refer to the Modified Table of Organizational Equipment

(MTOE) applicable to your unit.

5-2

SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.

Any special tools or equipment required by direct support maintenance personnel to perform maintenance on the

landing craft is listed In Appendix B of this manual.

5-3

REPAIR PARTS.

Repair parts are listed and illustrated in the repair parts and special tools list (TM 55-1905-222-24P) covering direct

support maintenance of this equipment.

Section II. TROUBLESHOOTING

5-4

TROUBLESHOOTING PROCEDURES.

This paragraph provides information useful in diagnosing and correcting unsatisfactory operation or failure of LCM-

8 systems and equipment. Troubleshooting procedures in this manual are limited to the basic craft. Refer to TM

5-2815-231-14 for engine and transmission troubleshooting procedures. Before using the troubleshooting procedures,

ensure that all applicable operating procedures have been performed.

NOTE

The table lists the malfunctions which may occur during the service life of the equipment.

Replace all defective parts when repairing an equipment unless machining or other repair

process can return the part to reusable condition.