| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
5-11 REPLACE HYDRAULIC GAUGES, RUDDER ANGLE INDICATOR AND AMMETER (Continued).
b.
Tag and disconnect wires (BLACK, RED, &
GREEN) from terminals 6, 8 and 4 respectively at
the rear of the indicator.
c.
Tag and disconnect positive and negative
terminals (RED AND BLACK) of the 24V supply
from the rear of the indicator.
INSTALLATION
INSTALL NEW RUDDER ANGLE INDICATOR.
a.
Connect three wires to terminals 6, 8 and 4 at the
rear of the indicator.
b.
Connect positive and negative terminals of the 24V
supply to the indicator.
c.
Set new rudder angle transmitter into place on the
instrument panel (5).
NOTE
Align and adjust rudder angle indicator before proceeding with the following
steps..
d.
Seal rudder angle indicator to the instrument panel
with good grade adhesive.
e.
Install gasket (3) and cover glass (2) and secure
with fourteen tapping screws (1).
5-29
|
||
|
||
