| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-10
REPAIR RAMP WINCH (Continued).
c. Assemble the primary planet gears (48) with
cam locks (52 and 53), garter springs (51)
and roller bearings (50) as follows.
(1). Install one snap ring (54) in a primary
planet gear (48). Grip the primary planet
pin (46) on the thrust plug end and install a
roller bearing (50) over the end of the
primary
planet pin (46) so that it rests on
your hand. Then place the primary planet
gear (48), assembled with the snap ring (54)
as above, over the planet pin so that the
bearing (50) pilots into the bore of the
primary planet gear and locates against the
snap ring (54).
(2). Now take sixteen cam locks (52) and one
copper colored cam lock (53) and assemble
them so that they stand on end between
the primary planet pin (46) and the bore of
the planet gear (48).
(3). Install a second snap ring (54) and make
sure that it is properly seated in the
bottom of the snap ring groove all the way
around the gear. Place a roller bearing (50)
in the bore of the planet gear so that it rests
on the snap ring (54).
NOTE
Before installing the garter spring (51) check to see that the groove formed by the notches
at the end of the cam locks (52 and 53), next to the snap ring (54), is fully exposed.
6-51
|
||
|
||
