| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-10
REPAIR RAMP WINCH (Continued).
d.
Install the sun gear shaft in the winch so that
it engages in the splined bore of the primary
planet hub. Slide the sun gear shaft (10) in until
the snap ring (5) contacts the end of the primary
planet hub. At the same time 'O' ring (12) will
contact the seal face on the end of the drum
and be pushed up the tapered diameter of the
tapered seal ring (13).
e.
Install the final planet assembly (9) so the
planet gears engage in the Internal teeth of the
final housing (3). Tap the planet assembly
(9) into place until it contacts the bearing that
carries the drum in the final housing (3).
f.
Install thrust plate (8) in the end of the final
planet assembly (9).
g.
Lubricate 'O' ring (7) with grease and install in
its groove in the end cover (6). Give 'O' ring
an additional coat of grease.
h.
Install end cover (6) in final housing (3) so that
the filler boss is located at the bottom of the
final housing when the winch is mounted. Make
sure that the end cover is properly seated
against the gear teeth in the final housing.
i.
Install snap ring (5) and make sure it is properly
seated in the bottom of the snap ring groove all
the way around the housing (3).
j.
Fill the final housing (3) with SAE 90
transmission oil to the level of the filler hole and
install the filler plug.
6-56
|
||
|
||
