| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-19 REPAIR STARTING MOTOR (Continued)
d. If removed, install roller bearing (29) in
port plate (7), securing with retaining ring
(28)
e. If removed, install adapter fitting gaskets
(27), and adapter fittings (26).
f. Install washer (25), spring (24), and
washer (23) onto motor barrel (10).
g. If removed, install dowel pin (22).
h. Press thrust bearing (21) into housing
(19), and Install housing (19), and thrust
bearing plate (20). Press in housing until
it bottoms against housing (4). Be sure
dowel pin (22) is in place
i. Install drive shaft ball bearing (18) on
drive shaft, and secure with retaining ring
(17)
j
Install with seal holder (16).
k Install outer seal (15), slipper seal (14),
and inner seal (13) onto drive shaft
I. Press assembled drive shaft (6) into
housing (4) from port plate end (7).
m. Secure with retaining ring (12).
n Install pistons (11) onto barrel (10), and
install barrel (10).
o. Position assembled port plate (7) onto
motor housing (4).
p. Align scribe marks on port plate (7) and
motor housing (4).
q. Secure with lockwashers (9) and screws
(8) Torque screws to 300 lb in (33 89
Nm).
6-106
|
||
|
||
