| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
(6) Calibrate. To determine and cause corrections to be made or to be adjusted on Instruments or test
measuring and diagnostic equipments used In precision measurement. Consists of comparison or two instruments, one
of which is a certified standard of known accuracy to detect and adjust any discrepancy In the accuracy of the instrument
being compared.
(7) Install. The act of emplacing, seating, or fixing into position an item, part, or module (component or
assembly) In a manner to allow the proper functioning of an equipment or system.
(8) Replace. The act of substituting a serviceable like type part, subassembly or module (component
or assembly) for an unserviceable counterpart.
(9) Repair. The application of maintenance services (inspect, test, service, adjust. align, calibrate, or
replace) or other maintenance actions (welding, grinding, riveting, straightening, facing, remachining or resurfacing) to
restore serviceability to an item by correcting specific damage, fault, malfunction, or failure in a part, subassembly,
module (component or assembly), end item, or system.
(10) Overhaul. That maintenance effort (service/action) necessary to restore an Item to a completely
serviceable/operational condition as prescribed by maintenance standards in appropriate technical manuals. Overhaul Is
normally the highest degree of maintenance performed by the Army. Overhaul does not normally return an Item to a
like-new condition.
(11) Rebuild. Consists of those services/actions necessary for the restoration of unserviceable
equipment to a like-new condition in accordance with organizational manufacturing standards. Rebuild is the highest
degree of material maintenance applied to Army equipment. The rebuild operation includes the act of returning to zero
those age measurements (hours/miles, etc. ) considered to classifying Army equipments/components.
d. Column (4) - Maintenance Level. This column is made up of sub-columns for each category of maintenance
Work time figures are listed In these subcolumns for the lowest level of maintenance authorized to perform the function
listed in Column 3 These figures Indicate the average active time required to perform the maintenance function at the
indicated category of maintenance under typical field operating conditions
e. Column (5). Tools and Equipment. This column is provided for referencing by code, the common tool sets (not
individual tools), special tools, test and support equipment required to perform the designated functions
f. Column (6). Remarks.
This column is provided for referencing by code of the remarks pertaining to the
designated functions
B-3
EXPLANATION OF COLUMNS IN SECTION III
a. Column (1). Reference Code. The tool and test equipment referenced code correlates with a maintenance
function on the Identified end item or component.
b. Column (2). Maintenance Level. The lowest level of maintenance authorized to use the tool or test equipment.
c. Column (3). Nomenclature. Name or Identification of the tool or test equipment.
B-2
|
||
|
||
