| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
Table 2-2. Operator/Crew Preventive Maintenance Checks and Service - CONT
B - Before
D - During
A - After
W - Weekly
M - Monthly
INTERVAL
PROCEDURES
EQUIPMENT IS
ITEM
ITEM TO BE
CHECK FOR AND HAVE REPAIRED
NOT READY/
NO
B
DA W M
INSPECTED
OR ADJUST AS NECESSARY
AVAILABLE IF:
97
Ship's Service
Diesel Generator
(STBD) -
continued
Start Control
Start engine and note action of
Unusual noise.
starter mechanism, particularly
Low oil
whether mechanism has adequate
pressure.
cranking speed and whether it
engages and disengages without
unusual noise when the control
is operated. Set throttle so
that the engine will run at
normal warmup speed until
prescribed operating
temperature is reached. If the
oil pressure gauges do not
indicate the proper pressure as
specified within 30 seconds,
stop the engine
98
Bilge/Ballast
Visually inspect pumps for
Pump is
Pump
leaks, loose connections and
defective or
damage. Check bilge/ballast
pressure
pumps gauges for normal
readings are
readings (discharge: 20-40 psi,
not within
suction: less than 10 psi). If
range.
suction is greater than 10 psi,
refer to unit maintenance.
99
Auxiliary Sea
Water
Circulating Pump
Strainer
Check that sea water strainer
Strainer is
is unobstructed,
obstructed and
can not be
cleaned.
Pump
Visually inspect pump for
leaks, loose connections and
damage. Check gauges for
normal readings (15 inches
suction, 0-40 inches
discharge).
2-269
|
||
|
||
