| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
(15) Ensure that the STEERING ROOM LOCAL CONTROL UNIT (FIGURE 2-149.3) , located in the
steering compartment, "MODE SELECT SWITCH" (1) is in the "REMOTE" position on each panel.
(16) Ensure that the STEERING GEAR MOTOR CONTROLLER PANEL (FIGURE 2-149.4)), located in
the steering compartment, "CIRCUIT BREAKER SWITCH" (1) in the "ON" position on each panel.
(17) Ensure that the STEERING GEAR MOTOR CONTROLLER PANEL (FIGURE 2-149.4) ,
"LOCAL/OFF/REMOTE SWITCH" (3) is in the "REMOTE" position on each panel.
(18) Ensure that the 24 VOLT DISTRIBUTION PANEL (FIGURE 2-149.5) , located in the
communications area, "STEERING CONTROL CONSOLE SWITCH" (2) is in the "ON" position.
b.
Steering Gear System Operation
(1) On the STEERING GEAR CONTROL PANEL (FIGURE 2-149.2) press the "LAMP TEST
PUSHBUTTON" (4) and ensure that all lamps light.
(2) On the STEERING GEAR CONTROL PANEL (FIGURE 2-149.2) adjust the "DIMMER CONTROL
SWITCH" (7) for best reading level.
(3) On the STEERING GEAR CONTROL PANEL (FIGURE 2-149.2) set the "PUMP SELECTOR
SWITCH" (2) TO THE "pump No. 1" position.
NOTE
The pump No. 1 run green power available indicator should light, if indicator
does not light, shutdown and notify unit maintenance.
(4) On the STEERING GEAR CONTROL PANEL (FIGURE 2-149.2) set the "MODE SELECTOR
SWITCH" to the "NON-FOLLOW-UP" position.
WARNING
Do not operate rudders without obtaining proper authority. Ensure that all
personnel and equipment are clear of rudder areas and other moving parts.
(5) Observe rudder operation as follows:
Change 2 2-425
|
||
|
||
