| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
(d) On Power Panel P204 set HOT WATER BOOSTER PUMP circuit breaker 4 to ON position.
(e) Ensure HOT WATER VALVE (3) is open.
(f) Ensure BAFFLE HANDLE (1) is open (pushed in).
(g) On Power Panel P211 set GALLEY EXH circuit breaker 7 and GALLEY MAKE-UP SUPPLY circuit
breaker 9 to ON positions.
(h) In Galley, on Motor Controller P211-7 set ON-OFF control switch (1, FIGURE 2-206) to ON position.
(i) In galley, on Motor Controller P211-9, set ON-OFF switch (1) to ON position.
(j) Press START pushbutton (2), on P211-7 and P211-9 Motor Controllers.
(2) Shutdown
.
(a) Press STOP pushbutton (5, FIGURE 2-205).
(b) This will start the automatic wash cycle.
WARNING
Wait until wash cycle is complete before opening inspection doors.
(c) Open inspection doors (2). If baffles are not clean, close inspection doors (2) and press START
pushbutton (4). After completion of wash cycle reinspect.
(d) Start fans by pressing START pushbutton (2, FIGURE 2-206) on MOTOR CONTROLLERS.
(e) Press STOP pushbutton (5, FIGURE 2-205) to start another wash cycle.
d. Electric Range (FIGURE 2-207).
(1) Range top operation
.
(a) Set desired LEFT-CENTER-RIGHT control (1) to 800 and preheat for 10 minutes.
F
(b) Appropriate indicator (4) will light.
(c) Set selected control to desired heat setting, place pot or vessel on range and cook.
(2) Range top shutdow.
n
(a) Shut down range by setting selected LEFT-CENTER-RIGHT control (1) to OFF position.
2-556
|
||
|
||
