| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
a.
Work-in-process inspections are accomplished by the assigned ship surveyor while the
vessel is in the contractor facility (shipyard) undergoing repairs.
b.
The objective of the work-in-process inspections is to insure that work called for in the
contract specifications is accomplished as specified and that workmanship and materials are to accepted
standards. The work-in-process inspections exclude acceptance dock and sea trials which are addressed in
paragraph 10.
c.
No separate in-process inspection report form is included since the scope of each vessel
OCCM will vary dependent upon requirements. Normally, the specific check points for a repair task are
included in the specification item.
d.
The type of repairs typically requiring Work-In-Process Inspections are listed in Section 6 of
the applicable Appendix. This list may be used as a guide in specification preparation.
e.
In addition to Work-In-Process Inspection Checklist, the surveyor will submit a weekly
progress report assessing the overall percentage of completion as well as a percentage completion for each
major area of repairs. The following guide will be used for the progress report.
Guide for Computing Percentage of Completion to be Included in Weekly Report
The weekly progress report shall show the overall job percentage of completion along with the percentage
amount of performance period which has been used as of the date of report preparation.
General Reports
5%
1.
Preparation prior to beginning actual work performance
10%
2.
Make necessary removals to permit access to or removal of designated items for delivery to
shop
10%
3.
Disassembly of items
15%
4.
Cleaning and inspection of items as designated
5%
5.
Required reports in hand
15%
6.
Repair and/or replacement of parts as authorized
10%
7.
Reassemble and/or test as applicable
10%
8.
Reinstall all removals in proper location
10%
9.
Perform operational tests and prove satisfactory
5%
10.
Clean and paint all disturbed areas
5%
11.
Furnish surveyor with final operational reports if required by Specification
Change 8 G-6
|
||
|
||
