| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
CAUTION
Do not use a hammer to push the access cover (18)
over the retainer (22). Damage to parts will result.
NOTE
The clearance between the access cover (18) and the
gear retainer (22) is small. Ensure the cover and
retainer are aligned properly so that the cover will touch
the body (31).
l. Install lockwashers (19 and 25) and machine bolts (20 and 24). Tighten machine bolts to 35 ft-lb (45 N m).
m. While turning compound gear (17), lubricate all gears and thrust bearings with clean engine lube oil. Cover
pump until installation to prevent the entry of dirt.
n. Assemble safety relief valve (4).
(1) Lubricate plunger (3) and bore of valve (4) with clean engine lube oil. Insert plunger in bore.
(2) Insert compression spring (2) in bore.
CAUTION
Parts are under spring pressure. The spring can move
with enough force to cause personal injury. Use a tool
that will control the parts firmly.
(3) Position washer (1) on end of spring (2).
(4) Push the parts into bore until washer (1) is beyond retaning pin (52) holes.
i
(5) Hold parts in position and install retaining pin (52). Use a small hammer and a drift to move the pin
through the hole in the body.
6) Use a small hammer. Install pin rollers (51) in retaining pin (52).
REPLACEMENT
NOTE
The lubricating oil pump is dowel fit to the cylinder block
on both sides.
a. Install oil pump (36).
3-70
|
||
|
||
