| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
FIGURE 3-23. Removal of Piston from Connecting Rod.
(2) Place assembly in water heated to 180 -212 (82 -100 ). Leave assembly in water for 3 to 5
F
F
C
C
minutes.
(3) Remove assembly from water. Turn piston (2) so remaining retaining ring (1) is positioned up.
NOTE
A brass drift and hammer can be used to remove a
scuffed pin. Use caution to avoid damage to the
connecting rod bushing.
(4) Tap the piston on a block of wood until the piston pin (3) slides out.
(5) Remove connecting rod (4) and retaining ring (1).
REPAIR
Repair of the connecting rod and piston group is by replacement of the piston and the connecting rod
assembly.
REPLACEMENT
a. Install piston on connecting rod.
(1) Install one retaining ring (6, FIG. 3-25).
3-83
|
||
|
||
