| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
NOTE
Reinstall liner so that polished area is in line with the longest centerline of the
crankshaft.
(9) Inspect outside of liner flange for wear. Wear is indicated by small areas that are polished
and by the absence of machining marks. Replace liner if an area over 0.5 inch (13 mm) in
length does not have machining marks.
NOTE
Reinstall liner so that polished area is 90 degrees from the longest centerline of the
crankshaft. An area that is not polished must be in line with the longest centerline
of the crankshaft.
(10) Inspect bottom of flange for absence of machining marks in polished areas. Replace liner if
an area over 0.5 inch (13 mm) does not have machining marks.
j.
Measure cylinder liner.
NOTES
Refer to Table 4-8 . for specifications.
The inside diameter of a new cylinder liner can be 0.0006 inch (0.015 mm)
smaller than specifications due to lubrite coating.
(1) Measure inside diameter of liner at top, middle, and bottom of piston ring travel area. Take
two measurements, 90 degrees apart from each other, at each location.
(2) Measure thickness of liner flange.
(3) Measure outside diameter of liner flange.
(4) Measure outside diameter of liner set secondary press fit location.
CAUTION
Do not set liners in an area where dirty air flow can contaminate liners.
k.
Apply thick film of clean 15W-40 oil to liner bores. After 5 to 10 minutes, wipe with clean lint-free paper
towel until black and grey deposits are removed.
4-95
|
||
|
||
