| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
FIGURE 4-91. Liner Protrusion Measurement.
(18)
Repeat steps (16) and (17) in four places equally spaced on the liner outside diameter. Ensure
measurements do not differ more than 0.001 inch (0.03 mm).
NOTE
A new bead of sealant must be applied if the liner is removed
and re-installed.
(19)
If liner protrusion exceeds specifications, remove liner and check for burrs and dirt. If liner is less
than specifications, use shims or an oversize ring to adjust the protrusion.
d.
Install engine lifting brackets.
CAUTION
Sealant must be applied on lifting brackets to prevent corrosion
of the bolts. Corroded bolts may break during engine lifting.
(1)
Apply RTV sealant account the threaded holes in the block for the lifting fixture bolts (70, FIG.
(2)
Apply a bead of sealant to the bottom of the bolt head. Install washer (69) on bolt (70). Apply a
bead of sealant to bottom of washer.
(3)
Install lifting bracket (68). Secure with bolt (70). Torque bolt to 200 ft-lb (270 N ).
m
e.
Install appear thrust bearing support.
4-103
|
||
|
||
