| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-10
DISASSEMBLY
a. Remove hexhead capscrews (2) from compensatory (11) and remove compensatory assembly from valve block
(21).
b. Remove retaining ring (12), gasket (13), preformed packing (14), and plug (1) from compensatory body. Discard
gaskets and packing.
c.
Remove wire (3), seal (4), plug (5), preformed packing (6 and 7), spring (8), seat (9) and spool-(10) from
compensatory body. Discard packing.
d. From pump housing (54) remove hex head capscrews (47) , covers (48), shim kits (49), preformed packing (50),
pintel bearing spacers (51), annular ball bearings (52), retaining ring (57), and shaft seal (56). Discard packing
and shaft seal.
e. From pump housing (54) remove hexhead capscrews (55), valve block (21), spring (46), seats (45 and 44), spring
pin (43), piston (15), rod (16), preformed packing (17), and housing gasket (53). Discard gasket and packing.
f. From valve block (21) remove plug (20), preformed packing (19), seat (24), valve (23), spring (22), pins (25 and
26), and compression spring (18), piston (15), rod (16), and preformed packing (17).
g. From pump housing (54) remove shaft assembly (40), yoke (41), and annular ball bearing (42).
h. From shaft assembly (40), remove annular ball bearing (27), wafer plate (28), bearing spacer set (29), retaining
ring (30), spring washer (31), spring (32), spring washer (33), cylinder block (34), pins (35), pin retainer (36),
spherical washer (37), shoe plate (38), and linear piston shoe (39).
4-9
|
||
|
||
