| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-10
NOTE
Port and starboard wire rope must be removed at the same time.
(2)
To remove wire rope (12) starboard side and port side remove turnbuckle jaw pin (10) from closed socket (11).
(3)
Refer to TM 55-1905-223-10 and start up bow ramp ass embly.
(4)
Operate bow ramp winch and unwind both wire ropes forming separate coils on deck to prevent snarls or kinks.
(5)
Refer to TM 55-1905-223-10 and shutdown bow ramp winch assembly.
(6)
Remove ends of wire rope (12) from winch assembly cable anchors (3, FIGURE 4-10).
(7)
Pull wire rope slowly from bow ramp sheave assemblies and wire rap glands into a coil on deck to prevent
snarls or kinks.
REPAIR
Repair of the bow ramp lifting assembly is accomplished by repair of the subassemblies. Maintenance procedures
for these subassemblies are contained in Chapter 4, following.
REPLACEMENT
a. Install bow ramp turnbuckle.
(1)
Attach turnbuckle to chain link (4, FIGURE 4-11).
(2)
Insert shackle pin (5) and secure.
b. Install stud chain.
(1)
Remove deck fitting lifting device.
(2)
To install stud chain (4), lay chain on deck and stretch out full length removing any kinks in chain. Feed bow
ramp end of chain through and over wildcat sheeve assembly and secure to lifting pod (2).
(3)
Refer to TM 55-1905-223-10 and restore the bow ramp assembly to normal operation.
4-53
|
||
|
||
