| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-10
c. Install wire rope.
NOTE
Install port and starboard wire ropes at the same time.
(1)
To install wire rope (12), lay wire rope on deck in a coil or roll off of a reel to prevent snarls or kinks.
(2)
Feed winch end of wire rope through sheeve assemblies and main deck to the winch drum using FIGURE 4-12
as a guide. Install end of wire rope into winch cable anchors (3, FIGURE 4-10) and secure to desired fit.
(3)
Operate winch slowly until wire ropes (12, FIGURE 4-11) are installed on winch drum using caution to ensure
that coils feed evenly and do not kink or snarl.
(4)
Stop winch so enough slack remains in wire rope to install turnbuckle (9, FIGURE 4-11). Insert closed socket
(11) end into turnbuckle jaw and install turnbuckle pin (10).
(5)
Operate winch and take up slack in wire rope adjust turnbuckle (9) until desired tension is reached. Secure
turnbuckle locking nuts (8).
(6)
Remove lifting device used to secure bow ramp and restore system to normal operation, TM 55-1905-223-10.
4-56
|
||
|
||
