| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-10
WARNING
o
Electrical components contain high voltages that can cause severe injury or
death. Before servicing, adjusting, or replacing electrical or mechanical
components tag "Out of Service - Do Not Operate" and disconnect the
power supply to the three control panels and the electrical motor in the
hydraulic power pack assembly.
o
The fumes from cleaning solvents are dangerous. Use solvents in open air
or well ventilated space. Wear proper eye protection and rubber gloves.
REMOVAL
a. Reference TM 55-1905-223-10. Start up bow ramp assembly, lower bow ramp to full down position. Shutdown,
secure and tag "Out of Service - Do Not Operate."
b. Using a hand scraping tool or mechanical tool, remove rubber strips (1, 2) from bow ramp. Clean seal c hannel to
a near white finish to ensure good contact surface.
c. Wipe out liner seating areas with cleaning solvent and blow clean with compressed air.
REPAIR
Repair of bow ramp sealing is by replacement.
REPLACEMENT
WARNING
Adhesives can contain chemical components that will irritate skin or eyes. Wear
proper eye protection and rubber gloves while handling.
a. Into cleaned liner seating area, apply proper mixture of adhesive and thinner.
b. Install rubber strips (1, 2).
4-77
|
||
|
||
