| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-10
Section IV. REMARKS
FOR
BOW RAMP ASSEMBLY
REFERENCE
REMARKS
CODE
A
UPON REMOVAL, REPLACEMENT OF THE ELECTRIC MOTOR, LOVEJOY COUPLING, OR THE
HYDRAULIC PUMP, THE ALIGNMENT MUST BE CHECKED.
B
THIS ITEM IS A CANDIDATE FOR DIRECT EXCHANGE WITH THE VENDOR.
C
GEAR REDUCER IS PART OF WINCH (INTERNAL) BUT IS ALSO A SEPARATE REPAIRABLE
ITEM. FOR MAJOR REPAIR, REMOVE THE GEAR REDUCER FROM THE WINCH. SUPPORT
THE WINCH DRUM WITH A LIFTING DEVICE AND / OR BLOCK SUPPORTS. REPAIR THE
WINCH BY THE SAME PROCEDURE. ALL INTERNAL PARTS OF THE GEAR REDUCER
SHOULD BE REPLACED IN SETS AND ORDERED BY PART NUMBER AND PREFIX OF STAGE.
D
IDENTIFICATION PLATE TO BE STAMPED I.A.W. DWG NO. C-13612 (BEEBE INTERNATIONAL
INC.).
E
TO REMOVE PISTON FROM POWER PLATE, INTRODUCE LOW PRESSURE AIR (15 PSI) INTO
THE HYDRAULIC INLET. MAKE SURE PISTON IS DIRECTED AWAY FROM OPERATOR.
F
DURING REPLACE / REPAIR OF HYDRAULIC SYSTEMS, ALL OPENINGS SHOULD BE CAPPED
/ PLUGGED TO PREVENT FOREIGN MATTER OR CONTAMINATION FROM ENTERING THE
SYSTEM.
G
PC #28 IS A SHIPPING PLUG, AND IS TO BE USED FOR PROTECTION OF FAILSAFE BRAKE
HYDRAULIC PORT DURING SHIPMENT, OR REMOVAL FROM SYSTEM.
H
THE EMERGENCY HANDCRANK IS TO BE INSTALLED ON THE OUTER END OF THE
HYDRAULIC MOTOR FOR EMERGENCY USE ONLY AND IS TO BE REMOVED PRIOR TO
NORMAL OPERATION OF THE WINCH SYSTEM.
I
REPAIR IS BY REPLACEMENT OF THE VALVES OF THE MANIFOLD ASSEMBLY.
J
REPAIR OF THIS ITEM IS BY REPLACEMENT.
K
DEPOT LEVEL REPAIR/MAINTENANCE WILL BE PERFORMED ON A CASE BY CASE BASIS
SUBJECT TO APPROVAL AND FUNDING BY THE NATIONAL MAINTENANCE POINT (NMP).
Change 3 B-9/(B-10 blank)
|
||
|
||
