| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-15
ASSEMBLY
a. Replace stator vane (14) and springs (15).
b. Replace rotor vane (10) and the inner and outer rotor vane springs (11 and 12).
c. Replace rotor (13) into the stator (16).
d. Install new preformed packings (14) into front and rear of stator (16).
e. Replace plates (18), front and rear of stator, and secure with screws (19) and headless pins (20).
f. Replace roller bearing (27) into the rear housing (8).
g. Install preformed packings (21, 22, 23 and 24) into the rear housing.
h. Replace rear housing onto the shaft (9).
i. Replace ball bearing (7) onto the shaft.
j. Replace retaining ring (6).
k. Install preformed packing (5).
l. Replace seal plate (4).
m. Install preformed packings (2 and 3).
n. Replace preformed packings (21, 22 and 23) into front housing (26).
o. Replace front housing (26) onto the shaft (9).
p. Replace four bolts (24). Torque to 115 ft-lbs.
q. Replace retaining ring (1).
r. Replace hydraulic motor assembly, paragraph 2-16.
s. Replace failsafe brake assembly, paragraph 2-15.
t. Restore bow anchor windlass to operating condition, paragraph 2-13.
CAUTION
Proper fluid must be used for compatibility with the seals, and the viscosity range must meet the
recommendations of the manufacturers or damage to the equipment will occur.
u. Operate the windlass and check the hydraulic motor.
4-33
|
||
|
||
