| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-15
ASSEMBLY
a.
Insert shaft (22) and bearings (11) into housing (25).
b.
Install grease retainer (12) onto shaft (22).
c.
Position gasket (13) and cap (23) to the housing (25) and secure with screws (24).
NOTE
Gasket (13) on the motor side will be installed with the motor.
d.
Install spacers (27) over pins (26) in gear (7),
e.
Position busings (8) to gear (7) and secure with bolts (28), nuts (10 and washers (9).
NOTE
Ensure that the key ways in bushings line up before securing to the gear.
f.
Set gear (7) into the housing (25).
NOTE
It may be necessary to turn shaft (22) slightly to mesh with gear (7). Bushings (8) will be firmly
sealed in the housing when gears are meshed.
g.
Position gaskets (6) to line up with bolt holes in housing (25).
h.
Install access cover (1) to housing (25). Secure with screws (5), nuts (15), and washers (14).
i.
Install screws (4), nuts (18) and washers (17) to complete securing access cover to the housing.
4-37
|
||
|
||
