REPLACEMENT - TM-55-1905-223-24-160047

Custom Search

FIGURE 2-6. Hydraulic Motor Assembly.

TM-55-1905-223-24-16 Stern Anchor Winch for Landing Craft Utility (LCU) NSN 1905-01-154-1191 Manual

FIGURE 2-7. Hydraulic Motor/Brake Assembly.iFIGURE 2-7. Hydraulic Motor/Brake Assembly.

TM 55-1905-223-24-16

(3) Disconnect failsafe brake pressure line connector (4) from hydraulic motor assembly (5).

b. Remove Hydraulic Motor Assembly. (FIGURE 2-7)

(1) Remove four mounting bolts (5) and four washers (6) from motor flange (4), failsafe brake (9), and mounting

flange (11) on gear reducer coupler (1).

(2) Separate motor (7) from brake (9) by sliding motor shaft (3) out of brake housing. Use suitable soft-face

hammer if necessary.

(3) Remove motor and flange gaskets (2).

REPLACEMENT

a. Install Hydraulic Motor Assembly. (FIGURE 2-7)

NOTE

Apply Permatex sealant to flange gasket prior to installation.

(1) Install flange gasket (2) on motor flange (4).

(2) Position motor (7) and flange gasket (2) into brake housing with boltholes aligned. Use rocking motion to

engage motor shaft (3) with brake coupler.

(3) Install four washers (6) and four mounting bolts (5) and secure motor/ brake assembly to gear reducer

coupler flange (11).

NOTE

Shafts must slide freely together. Do not use bolts to force units together.

(4) Tighten bolts sequentially and torque to 75-85 ft-lb.

2-31