| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-16
REPAIR
NOTE
This item is a candidate for direct exchange with the vendor.
Repair consists of replacing: inspection cover gaskets (33), fluid filter head (13), filter element (48), suction strainer (37),
pump (18), ac motor (51), breather (24), liquid sight indicator (28), dial indicator pressure gauge (23).
ASSEMBLY
a.
Dial Indicator Pressure Gauge.
(1)
Install pressure dial indicator gauge (23) into mounting port using hand pressure.
(2)
Position wrench on mounting flange at back of pressure gauge (23) and secure gauge to directional control
valve (22).
b.
Liquid Sight Indicator.
(1)
Position liquid sight indicator (28) over mounting holes on exterior wall of reservoir.
(2)
Reaching into interior of reservoir, install two mounting nuts (29) and secure indicator to reservoir.
c.
Breather.
(1)
Install nylon screen (27) into opening at top of reservoir.
(2)
Install mounting flange (26) over nylon screen with mounting screwholes aligned.
(3)
Install mounting screws (25) and secure mounting flange and nylon screen to top of reservoir.
(4)
Replace air filter cap (24).
d.
Reservoir Level/Temperature Switch.
(1)
From interior of reservoir, slide threaded portion of switch (45) up through mounting port at top of reservoir.
(2)
With switch held in position, secure switch to reservoir with mounting nut (44) installed at top of reservoir.
2-41
|
||
|
||
