Custom Search
 
  
 
TM 55-1905-223-24-16
d. Remove protective caps, plugs, inserts, wrappings, and tape when inspection/inventory is completed. Inspect
piping openings for damage. Wipe off dirt, grease, or protective films at time of installation.
e. Remove chocks from resilient mounted components.
4-5.
Deprocessing and Preliminary Servicing. See Chapter 2, Section II.
4-6. Initial Setup Procedure. Includes operational checks and inspections that are not performed for a routine startup.
Direct support maintenance personnel will perform initial setup in accordance with the operator's manual, TM 55-
1905-223-10.
4-7.
Normal Startup. Refer to the operator's manual, TM 55-1905-223-10.
4-8.
Shutdown Procedure (Usual or Unusual). Refer to the operator's manual, TM 55-1905-223-10.
SECTION III. INTERMEIATE GENERAL SUPPORT PREVENTIVE
MAINTENANCE CHECKS AND SERVICES (PMCS)
4-9.
PMCS. There is no PMCS at the general support level. See Chapter 2, Section III.
SECTION IV. INTERMEDIATE GENERAL SUPPORT TROUBLESHOOTING
4-10. Troubleshooting. Both a symptom index and a troubleshooting table are provided. The symptom index will help
you locate the information you need for troubleshooting.
SYMPTOM INDEX
Troubleshooting
Procedure
(Table 4-1)
HYDRAULIC SYSTEM
Temperature too high
Item 1
No or low hydraulic pressure
Item 3
External hydraulic fluid leakage
Item 4
WINCH
Rotates too slow/will not rotate
Item 2
4-2

 


Privacy Statement - Copyright Information. - Contact Us

 Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business