| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-16
(2)
Remove brake reducer mount (1). Refer to removal task, step u., above.
(3)
Remove brake reducer coupling (2). Refer to removal task, step v., above.
(4)
Remove four hexagon head capscrews (3) and lockwashers (4) securing bearing retainer (6) to gear box.
CAUTION
Cover keyway with tapes, and remove set screw marks, nicks, or burrs to avoid damage to seal.
(5)
Withdraw bearing retainer (6) and oil seal (7) from high speed shaft (5).
(6)
Remove two recessed socket head capscrews (10) and thirteen flush mounted socket head capscrews (17)
securing upper housing (8) to lower housing (24).
(7)
Remove eight hexagon head capscrews (15) and lockwashers (14) securing bearing retainers (13) on each
side of gear box.
CAUTION
Cover keyway with tape, and remove set screw marks, nicks, or burrs to avoid damage to seal.
(8)
Withdraw bearing retainer (13) and oil seal (12) from winch shaft (16) on opposite side of gear box.
NOTE
Bearing retainer and oil seal closest to spool are only removed when spool is separated from winch shaft.
(9)
Remove eight hexagon head capscrews (18) and lockwashers (19) securing bearing retainers (20) on each
side of gear box.
(10) Remove bearing retainers (20).
(11) Remove eight hexagon head cap screws (21) and lockwashers (22) securing bearing retainers (23) on each
side of gear box.
(12) Remove bearing retainers (23).
(13) Use two jack screws in mounting screw holes at both ends of upper housing to break sealant bond between
upper and lower housing.
4-36
|
||
|
||
