| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-16
s.
Levelwind Side Frames. (FIGURE 4-9)
NOTE
Four soldiers are required for replacement procedure.
(1)
Position levelwind side frame (3) over base of winch platform with mounting boltholes aligned.
(2)
Install two recessed hexagon head capscrews (4), lockwashers (5), and hexagon plain nuts (6) to secure
levelwind side frame to winch platform.
(3)
Attach lifting sling (1) to levelwind carriage (2).
(4)
Position levelwind carriage for installation of diamond shaft (11).
(5)
Slide diamond shaft (11) through lower section of levelwind guide (12) and engage with levelwind side frame
(3).
(6)
Position levelwind side frame (10) over mounting holes on winch platform and engage with diamond shaft
(11).
(7)
Install two recessed hexagon head capscrews (7), lockwashers (8), and hexagon plain nuts (9) to secure
levelwind side frame (10) to winch platform.
(8)
Lifting sling is temporarily left in place to support levelwind carriage during replacement procedures.
t.
Diamond Shaft Pawl. (FIGURE 4-8)
(1)
Install diamond shaft pawl (13) into interior of pawl cap flange (14).
(2)
Install pawl cap (12) over pawl cap flange with mounting holes aligned.
(3)
Install eight hexagon head capscrews (10) with lockwashers (11) to secure pawl cap to pawl cap flange.
u. Shaft Guide. (FIGURE 4-8)
(1)
Ensure that lifting sling (1) supports weight of levelwind carriage (2).
NOTE
Four soldiers are required for shaft guide replacement procedures.
Shaft guide can be installed from either end of levelwind carriage.
4-53
|
||
|
||
