| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
(5) Insert hex capscrew (3).
(6) Remove tags and connect electrical leads to solid surface unit (1).
(7) Insert solid surface unit in twin panel assembly (2).
Replacement of rectangular hot plate includes:
b.
NOTE
If adjoining hot plates were separated in removal,
be sure to thoroughly clean carbon and grease from
key strip (12, Sheet 2) area and edges between the
p l a t e s for proper fit.
(1) Insert six capscrews (18) and large washers (15) holding heating elements
(13 and 14) to element clamp plate (22).
(2) Insert clamp plate on top plate (11) corner studs (17) with four hex nuts
(17) and large washers (15).
(3) Insert element baffle (21) with four hex nuts (17).
(4) Insert element shield (20) with four hex nuts (17) and washers (19).
(5) Remove tags and connect electrical leads to heating elements (13 and 14).
NOTE
If adjoining hot plates were separated in removal,
f i t plates together at key strip (12). Align
latches (24) at front and back edge and insert hex
capscrew (23) to secure hot plates.
(6) If hot plates propped up for removal, remove prop and lower adjoining top
plates (11).
c.
Install electric range assembly and mounting bolts, if removed.
d.
Remove tags and connect electrical leads.
2-298
|
||
|
||
