| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
NOTE
If the unit does not shut off before the ram comes
off of the power screws, adjustment is required.
Open compactor drawer (3).
(1)
Remove machine screw (2) and remove control escutcheon (1).
(2)
Tag and disconnect electrical leads.
(3)
Loosen top and bottom screws (5) retaining sensitive switch (4).
(4)
Tilt the bottom of the switch outward.
(5)
Tighten top and bottom screws (5).
(6)
Shut compactor drawer (3).
(7)
Remove tags and connect electrical leads.
(8)
Install control escutcheon (1) and machine screw (2).
(9)
Remove out of service tags and apply power to unit.
(10)
Cycle unit to verify proper operation.
(11)
Repeat procedure as necessary for proper operation.
(12)
To adjust the drive chain (8, Sheet 2) perform the following:
b.
Remove solid waste compactor.
(1)
Lay unit on side.
(2)
Remove screw (6) and remove bottom pan (7).
(3)
Loosen bolt (10) to permit movement of mount plate (11).
(4)
Pull mount plate with driven gear (9) and sprocket attached to tighten
(5)
drive chain (8).
NOTE
Adjust the drive chain to allow 1/4 inch
deflection across the drive socket.
Tighten bolt (10) to secure mount plate.
(6)
Install bottom pan (7) with screw (6).
(7)
Upright unit.
(8)
Replace solid waste compactor.
(9)
2-349
|
||
|
||
