| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
c.
Remove washer machine (1) cabinet top (2) as follows:
(1) Remove machine screw (3) and control panel (4).
Disconnect control hood wire harness from base wire harness at quick
(2)
disconnect block.
(3) Disconnect pressure hose (5) from pressure switch (6).
(4)
Push base wire harness block and pressure hose down through hole in
cabinet top.
(5) Tape loading door (7) closed.
(6) Remove assembled washer screw (8) and speed nut (9).
(7) Lift front of cabinet top slightly and pull forward to disengage from rear
hold-down brackets and disconnect green ground wire from rear top flange
of cabinet.
(8) Carefully lift cabinet top off washer and set on protective padding.
Remove plug (1, FIGURE 2-69).
d.
Remove hexagon head capscrew (3), trigger (4) and lo&washer (2).
e.
f.
Remove spring clip (7) and outer tube cover (5).
Remove cover gasket (6).
g.
Remove hexagon head capscrew (3, FIGURE 2-70) and gasket (4).
h.
Remove washtub (5).
i.
j . Remove fastener (1) and lint filter (2).
Remove gasket (6).
k.
l.
Remove hexagon plain nut (7) and lockwasher (8).
Remove encased plain seal (9).
m.
n.
Remove spring (27, FIGURE 2-74).
Position idle lever (9) to prevent damage when removing outer tub.
o.
NOTE
When removing the centering springs, mark on
side of outer tube what notch the spring was
hooked into. Springs must be placed in same
notch when reinstalling. Do not overstretch
springs.
Remove center spring (9, FIGURE 2-69).
p.
2-369
|
||
|
||
