| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
(FIGURE 2-80)
Replace Dryer Cabinet, Exhaust Duct, and Base Group.
2-94.
a. Removal, b. Replacement.
This task covers:
INITIAL SETUP
Equipment Condition
Tools
Dryer removed, para. 2-89.
Tool kit, general mechanic's,
Dryer front bulkhead and cylinder
assembly removed, para. 2-90.
Dryer rear bulkhead and cylinder roller
group removed, para. 2-91.
Dryer heater box group removed, para.
-2-92.
Dryer motor and exhaust fan group
removed, para. 2-93.
Remove the front panel, refer to paragraph 2-90.
a.
To remove the control panel perform the following:
b.
(1) Loosen set screw and remove knob (1) and knurled nut (2) from temperature
s w i t c h (5) shaft.
(2) Remove machine screw (3) and speed nut (6).
(3) Partially remove control panel (9).
(4) Tag and disconnect electrical leads from switches (5 and 8) and indicator
l i g h t (10).
(5) Remove lock washer (4) from temperature switch shaft.
(6) Remove control panel (9) from dryer unit.
Tag and disconnect all electrical leads to components in control hood (7),
c.
and ground wire (13, Sheet 2) after removing hex head cap screw (12).
Remove electrical lead wiring harness by pushing through opening in cabinet
d.
top (14).
Remove cabinet top washer screws (15) and speed nuts (16) in front corners of
e.
unit.
2-403
|
||
|
||
