| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
Remove cotter pins (5) from cylindrical pins (3).
c.
d.
Remove cylindrical pins (3) from hinge blades (2).
Remove flat washers (4) then remove door (1).
e.
DISASSEMBLY
NOTE
Disassembly/assembly procedures for both
left and right hand doors are the same.
a.
Remove hex nuts (6, FIGURE 2-171) and handles (7) from door (1).
b.
Remove bronze bushing (5) and preformed packing (4) from door.
c.
Remove dog door closer (9) from door.
NOTE
Refer to TM 55-1900-204-24 for detailed
cutting and welding procedures.
d.
Remove pipe sleeve (8) from door.
e.
Remove gasket retainer (10) and gasket (11) from door.
f.
Clean gasket channel thoroughly.
NOTE
After removing the old gasket, the entire
gasket channel should be thoroughly cleaned.
Remove stops (2) and flanged plate (3) from door.
g.
REPAIR
Repair at this level of maintenance is by replacement of: gasket (11), preformed
packing (4), oilite bronze bushings (5), and defective structural parts of the
door.
ASSEMBLY
a.
Install flanged plate (3) and stops (2) on door (1).
b.
Measure the required length around the door for the gasket,
Add one additional inch for each 36 inches of channel and cut gasket.
c.
2-682
|
||
|
||
