| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
Remove engine fuel tank (12).
i.
REPAIR
Repair at this level of maintenance is by replacement of spark plug (11), fluid
filter element (4), propeller assembly (8), and engine fuel tank (12).
ASSEMBLY
Install engine fuel tank (12).
a.
Connect fuel hose (14) to connector receptacle (13).
b.
I n s t a l l fluid filter element (4) into filter cup (5).
c.
Screw filter cup into filter base (3).
d.
Grease propeller shaft splines (10) with water resistant grease.
e.
Align propeller assembly (8) splines with propeller shaft splines (10)
f.
and install propeller assembly against thrust washer (9).
I n s t a l l nut (7) and torque to 55 ft-lb (75 Nm). Install cotter pin (6).
g.
Set spark plug (11) gap to 0.017 - 0.18 in. (0.5 - 0.6 mm).
h.
Install new spark plug finger-tight and torque to 14 ft-lb.
i.
Install spark plug wire.
j.
I n s t a l l cowling (1).
k.
Lift engine onto transom of workboat.
a.
Tighten mounting clamps until engine is secure.
b.
Connect fuel line (14) to motor.
c.
INSPECTION
Make sure engine fuel tank is full.
a.
Make sure fuel line is firmly seated in connector receptacle and check
b.
for fuel leaks.
Check propeller assembly for chipped or bent blades. Make sure cotter
c.
pin is in place.
Visually inspect the entire engine.
d.
2-730
|
||
|
||
