| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
(3) Lift transformer out of motor controller (34).
Fuseholder block.
h.
(1) Tag and disconnect electrical leads from fuse blocks (8) and (9).
( I n t e r n a l wiring).
(2) Remove fuse cartridges (10 and 11).
(3) Remove two plain hex nuts (12), lockwashers (13) and machine screws (14)
from each fuse block.
(4) Remove fuse blocks.
Terminal block (receptacle).
i.
(1) Tag and disconnect electrical leads from terminal block (15). (Internal
wiring).
(2) Remove two plain hex nuts (16), lockwashers (17) and machine screws (18)
from each terminal block.
(3) Remove terminal block (15).
Circuit breaker.
j.
(1) Tag and disconnect electrical leads from circuit breaker (1).
(Internal
wiring).
(2) Remove self-locking screw (2) and detach switch cover.
(3) Loosen circuit breaker mounting screws.
(4) Separate circuit breaker (1) from connector assembly (3).
( 5 ) Lift circuit breaker out of motor controller.
FIGURE 2-201 (Sheet 3 of 3)
Push switches/indicator lights.
k.
(1) Position motor controller door (35) on a clean flat surface.
(2) Remove two screws from protective cover over each push switch and
indicator light at rear of door.
(3) Remove protective covers.
(4) Push switches.
(a) Push switch (36).
1 Tag and disconnect electrical leads from push switch (36) at rear of
door.
2 Unscrew locknut (38) from push switch at front of door.
2-800
|
||
|
||
