| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
(2) Remove four plain hex nuts (6), lockwashers (7) and machine screws (8)
from rotary switch.
(3) Remove rotary switch.
Push switches.
j.
(1) Push switch (15).
(a) Unscrew lock nut (16) from push switch (15) at front panel flange.
(b) Remove push switch from rear of flange.
(2) Push switch (17).
Refer to steps (1)(a) and (b) to remove push switch (17) and lock nut
(18).
(3) Push switch (19) and 20).
Refer to steps (1)(a) and (b) to remove push switch (19, 20) and lock nut
(21).
Repair of motor controller consists of replacing: M o t o r starter (22), electrical
c o n t a c t kit (24), interlock (26), shunt coil (25), electrical contact assembly
(27), transformer (1), fuse cartridge (29), (34), radio frequency coil (23).
Push switches.
a.
(1) Push switch (19, 20).
(a) Position push switch (19, 20) at rear of front panel flange.
(b) Install lock nut (21) on push switch.
(2) Push switch (17).
Refer to step (1)(a) and (b) to install push switch (17) and lock nut (18).
(3) Refer to step (1)(a) and (b) to install push switch (15) and lock nut
(16).
b.
Rotary switch.
(1) Position motor controller (35) on a clean flat surface.
(2) Position rotary switch (5) on motor controller with mounting screw holes
aligned.
2-824
|
||
|
||
