| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-2
REPAIR
a. Inspect flexible coupling element (4) for cuts, tears, or other signs of failing rubbermaterial. Replace element if it
is not repairable.
b. Discard all spring pins (2, 7, 8, 19, and 20).
c.
Inspect all other components for signs of damage and replace any component that cannot be repaired.
ASSEMBLY
NOTE
Make sure that the alternating spring
pin/bolt sequence is correct. The pins
fit tightly; do not force them into holes.
a. Install spacer ring (12) between element sections (4).
b. Replace spring pins (7 and 8) in the inner retaining ring (11).
c. Insert the hub (15) through the element (4) and spacer ring (12) and mate holes in the hub (15) with the spring pins
in the retaining ring (11). Install bolts (9) and washers (10).
NOTE
Do not tighten bolts (9) at this time.
d. Install bolts (5) through the hub (15), element (4) spacer ring (12), and inner retainer ring (11) and install self-
locking nuts (6). Tighten nuts (6) and bolts (9) alternately and evenly.
e. Replace spring pins (2) in the housing (1).
f.
Position the housing (1) to the element (4). Make sure bolt h les match up.
o
g. Mate the outer retainer ring (3) to the pins (2) in the housing (1).
h. Install bolts (14) and washers (13) through the housing (1) and element (4) to the outer retaining ring (3). Tighten
bolts alternately and evenly.
i.
Replace spring pins (19, outer) and (20, inner) in the hub (15).
j.
Position the connector flange (16) over the pins (19 and 20) to the hub (15).
3-13
|
||
|
||
