| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-2
b. External intermediate shaft:
(1) Remove screws (11) securing oil distributor (10).
(2) Remove the oil distributor.
REPAIR
a. Inspect both oil distributors (10) for clear fluid passage, oil sludge deposits, corrosion, or other obstructions. Clean
with solvent and clean rags, or replace as required.
b. Inspect the oil pump (24) for clear fluid passage and ensure that the shaft turns freely and smoothly. Clean with
solvent and clean rags, or replace as required.
c. Inspect both bearings (3) for proper lubrication, smooth races, or evidence of p ysical damage. Replace as
h
required.
ASSEMBLY
a. External input shaft:
(1) Install rear of the housing (16) with bolts (5) to the reduction gear.
(2) Replace bearing (3), gear shaft pump drive (18), locking plate (19) and shaft nut (20).
(3) Replace oil pump (24) onto housing (16) and secure with the screws (12).
(4) Replace pump gear (14) onto oil pump (19) and secure with straight pin (13).
(5) Install rear housing to front housing.
(6) Install screws (15), pin/nut assemblies (21), and capscrews (22).
(7) Replace oil distributor (10) and secure with screws (11).
b. External intermediate shaft:
(1) Replace bearing (3).
(2) Install shaft nut (8) and straight pin and washer (2).
(3) Install cover (1) and secure with screws (9).
(4) Replace oil distributor (10) and secure with screws (11).
c.
Replace external intermediate shaft, paragraph 3-11.
d. Start engine, referring to TM 55-1905-223-10, and check the external input/intermediate shaft for oil leaks. Correct
any troubles.
3-19
|
||
|
||
