| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-2
NOTE
Do not use the shaft for 24 hours. This time will
allow hydraulic fluid to completely drain.
d. Replace clutch cover attaching hardware.
(1) Replace hexagon screw (29) and nut (28) into the clutch cover (33).
(2) Replace capscrew (34) and return springs (35) into clutch cover (33).
(3) Replace ring spacer (32) with screws and washers (31).
e. Install check valves (30) into clutch cover (33).
f.
Install rear shaft bearings using hydraulic press.
(1) Install rear shaft bearing (24).
(2) Replace ring spacer (23).
(3) Install new shaft sealing ring (22).
(4) Replace bearing nut (20).
(5) Replace assembled washer/screw (21).
(6) Replace cover (19).
(7) Replace nut (16).
(8) Replace capscrews (17).
(9) Replace straight pin (18).
(10) Replace nut (15).
(11) Replace assembled was er/screws (14).
h
g. Replace input shaft. Reference para. 4-8.
415
|
||
|
||
