| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
CAUTION
If spacers or shims are used between the starter mounting flange and the flywheel
housing, mark their position, and save. Use the same spacers or shims, placed in
marked positions, when installing a new or rebuilt starter.
REPLACEMENT
NOTE
Ensure mounting surfaces are clean before installing starter.
a.
Replace all spacers or shims that were removed with the starter. Place them in their original position.
b.
Position the starter on the flywheel housing. Ensure the bendix gear teeth engage the flywheel gear.
c.
Install the capscrews (5). Tighten alternately to specified values as follows:
NOTE
Capscrews are alternately torqued to the specification in item (1); then item (2); then
item (3); and finally item (4).
Tighten to 25 ft-lb (34 N ) torque.
(1)
m
Tighten to 50 ft-lb (68 N ) torque.
(2)
m
Tighten to 75 ft-lb (102 N ) torque.
(3)
m
Tighten to 100 ft-lb (136 N ) torque.
(4)
m
d.
Connect the relay valve (2) with bushing (11) and nipple (10).
e.
Connect the air inlet (6), air outlet (7), and vent port (8) lines to the starter. Tighten to 35 in-lb (4 N m) torque.
f.
g.
Connect the air supply fitting (3). Tighten to 65 ft-lb (88 N m) torque.
h.
Connect the relay valve input signal port fitting (1) and supply port fitting (4). Tighten fittings to 35 in-lb (4 N m)
torque.
i.
Remove tag and open the external air supply valve to the starter.
2-55
|
||
|
||
